Author: stcckronsc1

Yesterday, In class I started my lasers project. In lasers I am going to make a show with music corresponding with what the show shows. I put the song v12 by Iann Dior into beyond, which I am using to make the show and I made a introduction to the song.

Yesterday, 10/25/21 I worked on Jack Anderton’s Bike. At first, when you are tuning a bike you have to clean it Mr. Thocker said so we cleaned it. It started out with paper towels and some cleaner spray they had made already. I sprayed the paper towel with the spray then wiped down the frame of the bike. I also cleaned the tires and spokes and took off mud. Then we were messing with the suspension and fixing it to Jacks weight so we first evened the two front fork suspension then we fitted it to jacks with the pressure. We found out where Jack was at first and how much travel there was in Jacks front fork suspensions. Then Mr. Thocker opened up the top of the suspension and added some airpressure.

When Mr. Ollila came here, I didn’t know what to expect. Mr. Thocker said he was goofy but not much else. Mr. Ollila talked about inventing and what he did and how to start. He makes inventions for the common population good. I perceived him as a very talkative, loud guy. He really understood how to get a crowds attention and how to interact with the crowd. Mr. Ollila kind of talked about how he talks to a crowd and is very confident and even BS’s a little bit. He told us about how if you’re going to commit to being a inventor, you have to go all-out.

In Science for Inventors, I am planning to make a laser show. The lasers will correspond with the music I choose. I want to choose somewhat of a story type song. I may even do a rap but it would be a faster pace with the lasers. I can use pre-edit configurations and make them move and describe the story as the song goes along. The whole show will be as long as the song.

In Science for Inventors, We have been learning the introduction the 3 catagories, Lasers, 3-D Printing, and Virtual Reality. Everyone has been divided into three groups depending on their leading interest. I am in Lasers because I am interested in Lasers and making them into a show with music and other effects. Lately, I have been making a doc about the safety protocol and what to not do. It has been very interesting furthering my interest into Lasers and how to work them.